AREA419 ZERO SHELLHOLDER SYSTEM ZERO

As people in Area 419 has done round after round of press testing, both with the ZERO and other presses, they have known that the very best way to get consistent sizing time and again is to have contact between the shellholder and the die. This removes your ability, however, to dial in your shoulder bump. Until now.

With the new ZERO Modular Shellholder System you can set up your shellholder to your die and have more consistency, more repeatability, and less hassle.

This system allows you to dial in the bump with a set of 6 precision ground stainless steel inserts .002″ at a time.

The Kit comes with:

– ONE Base

– THREE Shellholder/Extractor tops, sized for 223, 308, Standard Magnum (or similar)

– SIX Precision Ground headspace inserts ranging from +.002″ to -.008″

– ONE Aluminum Storage Block